Free Simple Circuit Diagram
Hydrophone is a tool like microphone, but this tool is used in the underwater environment. When used to pick up a sound on the air then this tool becomes less sensitive because it’s mechanical-acoustical properties is designed to match the Acoustical impedance of water. Circuit shown in this article is the hydrophones of a low noise amplifier with DC-servo. To […]
Read more
Only with a single chip active component (4069 IC), this circuit will convert sine to square waves without a power-source. To test some audio instruments, we can use this circuit. Device purpose: This circuit intended to pick up the a sine wave from an existing generator and then converts that wave into good square waves. This circuit doesn’t need power-source, […]
Read more
Introduction Humidity is the amount of water vapor in the air, expressed as a percentage of the maximum amount that the air could hold at the given temperature. To build a humidity sensor can be difficult because of their wide dynamic range and sensor’s drive requirement. But we can build the humidity sensor with reasonable accuracy within the chosen range […]
Read more
Fading a video signal can’t be done simply by attenuating the composite signal, since the synchronization signal may drop below unacceptable level. Here a circuit to overcome the problem: Most of video signals will works with this circuit, except for very noisy or distorted signals. The rest circuit is an LT1251 video fader (U2) configured to fade the signal ranging […]
Read more